performing wipe request after AD account has been disabled.

In 2010, if you disabled an AD account, a wipe request would not work on a phone if the phone had not syncd in a while.

This is obviously a problem because the 2 actions normally go hand in hand.

is there any way to get around this in 2010? has this been changed in 2013?

I ask because many times ive been asked to wipe phones but for whatever reason(no signal or off) the phone doesn't get the wipe command. so I end up disabling the account. at this point when the user does get signal again or turn the phone back on it will not be wiped.

thanks.